| Bruce Kaiser 2004-01-23, 7:47 pm |
| Does anyone have this working? I am trying to connect to an Actiontec
wireless gateway.
I have downloaded the rtl8180 drivers (rtl8180_linuxdrv_v13(gcc3.xx).zip),
unzipped and compiled then installed per directions.
The following is the script I used to to configure and activate. Nothing!!!!
Any suggestions.
I have kernel 2.4.18-4 and gcc version 3.2.
Everyting works in windowxp but not in linux
Thanks in advance.
----------------------
script
#Load module
/sbin/insmod -f rtl8180_24x.o
#Set SSID
/sbin/iwpriv wlan0 wlan_para ssid2scan=home
/sbin/iwpriv wlan0 wlan_para ssid=home
/sbin/iwpriv wlan0 wlan_para networktype=infra
#/sbin/iwpriv wlan0 wlan_para encmode=wep
#/sbin/iwpriv wlan0 wlan_para
wepmode=wep40,wepdkeyid=0,wepkey40_1=123
4567890
#Enable wireless lan driver
/sbin/iwpriv wlan0 wlan_para channel=6
/sbin/iwpriv wlan0 wlan_para basicrates=0xf
/sbin/iwpriv wlan0 wlan_para oprates=0xf
/sbin/iwpriv wlan0 wlan_para authtype=opensystem
/sbin/iwpriv wlan0 wlan_para wepmode=off
/sbin/iwpriv wlan0 wlan_para rtsthres=2304
/sbin/iwpriv wlan0 wlan_para fragthres=2304
#/sbin/iwpriv wlan0 wlan_para help
/sbin/iwpriv wlan0 enable
#Configure wlan0 IP address
/sbin/ifconfig wlan0 192.168.0.120 netmask 255.255.255.0 broadcast
192.168.0.255
route add -net default gw 192.168.0.1
echo "$(/sbin/ifconfig wlan0)"
|