| Glenn Rowe 2004-09-15, 8:47 pm |
| I am looking for help in creating a Part Mesh DMVPN
over Leased and DSL services.
What I currently have is two internet feeds with 2 x IOS Box's with the
Firewall/3DES IOS on which link into a larger OSPF Network accross
20+ sites. Both these boxes are located at different sites.
##################################
Box A
Leeds with a nework
eth0 10.10.10.1 255.255.255.0
ser0 10.10.20.1 255.255.255.252
ser1 10.10.20.5 255.255.255.252
OSPF area 0
Network 10.10.0.0 0.0.31.255
##################################
Box B
Manchester
eth0 171.29.100.1 255.255.255.0
Ser0 10.10.20.2 255.255.255.252
Ser1 10.10.20.25 255.255.255.252
OSPF area 0
Network 10.10.0.0 0.0.31.255
#################################
I have the 171.x network redistributed into the OSPF Network so all
10.10.0.0 client can get to the servers hosted at that site.
I have numerous DSL sites that connect to the 10.10.10.1 Router using
DMVPN with a tunnel that allows for OSPF to be sent over GRE. I have the
current setup so that all the VPN sites connect to 10.10.10.1 and then
route over my OSPF network to the 171.0.0.0 site. I would like to make use
of a Dual Hub type topology where the clients will create a tunnel to the
site it needs to get it's traffic from rather than to one site then over
our internal network.
Please could someone either help or advise a different way in which to
achieve this. If further information is required I will send through.
Regards
|