| Bernhard Albler 2005-11-20, 5:45 pm |
| Hi ryan,
jep, mtp required is set. I guess this is the issue. I will have to check w=
ith a colleague to see why it is configured this way (I fear it is for a re=
ason).
Many thanks as alyways
Best regards
bernhard
> -----Urspr=FCngliche Nachricht-----
> Von: Ryan Ratliff [mailto:rratliff@cisco.com]
> Gesendet: Sonntag, 20. November 2005 18:13
> An: Bernhard Albler
> Cc: cisco-voip@puck.nether.net
> Betreff: Re: [cisco-voip] MTP, G729 and CCM 3.2
> =
> Sounds like you have "MTP Required" set on the H.323 gateway config
> in CM. Since the software MTP in CM only supports g.711 your g.729
> call is not getting any MTP resources allocated. Since both
> endpoints support g.729 CM allows the call to proceed (this is
> changed via service parameter) however supplemental services (hold,
> transfer, conference, etc) are disabled for the call.
> =
> Do you really require MTP resources for calls via your H.323
> gateway? If it's an IOS device running any kind of recent code it is
> not really necessary. CM 3.2 doesn't support outbound H.323
> faststart nor the built-in bridge so you may not even need to use the
> MTP.
> =
> -Ryan
> =
> On Nov 20, 2005, at 10:20 AM, Bernhard Albler wrote:
> =
> Hi everyone,
> =
> =
> =
> I must say I'm currently dealing with a CCM 3.2 Implementation and
> since I have no experience with anything before 4.0, I'm a bit stumped...
> =
> There is a remote location which was recently switched to g729 and
> now they can't used hold, transfer and so on with a H323 Gateway (MTP
> problem, I know).
> =
> CCM traces complain about a Capabilities mismatch with the MTP. The
> IP Voice Media Streaming app has g729 activated and was restarted.
> =
> Should this work with 3.2? any ideas for further troubleshooting?
> =
> Many thanks
> =
> bernhard
> =
> ________________________________________
_______
> cisco-voip mailing list
> cisco-voip@puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
|