|
Home > Archive > Voice over IP Cisco > December 2005 > no ringback tone with call from PSTN->CCM->ATA
You are viewing an archived Text-only version of the thread.
To view this thread in it's original format and/or if you want to reply to
this thread please [click here]
| Author |
no ringback tone with call from PSTN->CCM->ATA
|
|
| duongquang phon 2005-12-26, 2:45 am |
| Hi all,
I have deployed a call scenario as follow:
PSTN---> AS5300---->CallManager----->ATA 186
and I have faced two problems as follow:
(i)first I see that CallManager converts all h323
messages with Faststart element that come from AS5300
or ATA into slow start mode.
(ii)Because of (i) all calls from PSTN to ATA will use
h323 slow start mode so it drives to another problem
as follow:
In slow start mode ATA 186 does not send h245 address
back to AS5300 until Connect message so no media
channel opened until Connect message so caller from
PSTN can not hear ringback tone from ATA. In oder to
solve this problem I have forced AS5300 to play
ringback tone locally by using command: tone ringback
alert-no-pi under voip dial-peer but sometimes it can
play sometimes can not.
Any thoughts?
Thanks,
Phon
=
________________________________________
___________________ =
Yahoo! Photos =96 NEW, now offering a quality print service from just 8p a =
photo http://uk.photos.yahoo.com
| |
| Ryan Ratliff 2005-12-27, 5:53 pm |
| Phon,
Later versions of CM do support H.323 fast start both inbound and =
outbound. Inbound faststart should be supported in 3.3 and later.
For your ringback issue check out http://www.cisco.com/en/US/tech/ =
tk1077/technologies_tech_note09186a0080094c33.shtml.
-Ryan
On Dec 25, 2005, at 11:26 PM, duongquang phon wrote:
Hi all,
I have deployed a call scenario as follow:
PSTN---> AS5300---->CallManager----->ATA 186
and I have faced two problems as follow:
(i)first I see that CallManager converts all h323
messages with Faststart element that come from AS5300
or ATA into slow start mode.
(ii)Because of (i) all calls from PSTN to ATA will use
h323 slow start mode so it drives to another problem
as follow:
In slow start mode ATA 186 does not send h245 address
back to AS5300 until Connect message so no media
channel opened until Connect message so caller from
PSTN can not hear ringback tone from ATA. In oder to
solve this problem I have forced AS5300 to play
ringback tone locally by using command: tone ringback
alert-no-pi under voip dial-peer but sometimes it can
play sometimes can not.
Any thoughts?
Thanks,
Phon
=
________________________________________
___________________
Yahoo! Photos =96 NEW, now offering a quality print service from just =
8p a photo http://uk.photos.yahoo.com
________________________________________
_______
cisco-voip mailing list
cisco-voip@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
|
|
|
|
|