| Burton, Jason 2005-07-26, 5:45 pm |
| I have the following setup IP phone-->CM4.1(3)->SIP trunk->CME
3.3(w/CUE2.1.2)
I can setup calls and hear voice ok, but when the call goes from left to
right I cannot transfer to VM on the CME system, I get reorder tones.
So for fun I thought I would dial the VM pilot number and I still get
reorder tones. Any help??
The dial peer for VM on CME is:
dial-peer voice 1 voip
description *** VM Pilot ***
destination-pattern 1900
session protocol sipv2
session target ipv4:10.1.1.10
dtmf-relay sip-notify
codec g711ulaw
!
Dial peer back to CM4.1(3)
dial-peer voice 3 voip
destination-pattern 2...
session protocol sipv2
session target ipv4:10.3.1.10
dtmf-relay sip-notify
codec g711ulaw
Then under CM I have a Sip trunk pointing to the CME gateway and a route
pattern that routes 1XXX to the Sip trunk.
Thanks in advance!!
|