| DeRooy, Aaron H 2006-02-09, 5:45 pm |
| Here's my dial peers:
voice-port 2/0:0
!
voice-port 2/1:0
!
dial-peer cor custom
!
dial-peer voice 202 voip
incoming called-number .
session protocol sipv2
session target ipv4:13.130.0.22
codec g711ulaw
!
dial-peer voice 100 pots
destination-pattern 9.......
port 2/1:0
Here's the "show call active voice bri" Notice the "no requesed circuit
(44)". My circuit is a DS0 T1. Any idea? The dial peers seem to be
matching OK.
13A5 : -1330532810ms.403 +-1 +1630 pid:100 Originate 92658093
dur 00:00:00 tx:0/0 rx:0/0 2C (no requested circuit (44))
Telephony 2/1:0 (405) [2/1.10] tx:0/0/0ms None noise:0dBm acom:0dBm
13A5 : -1330532820ms.404 +-1 +1680 pid:202 Answer aaron.derooy
dur 00:00:00 tx:0/0 rx:0/0 2C (no requested circuit (44))
IP 13.231.116.125:36182 rtt:0ms pl:0/0ms lost:0/0/0 delay:0/0/0ms
g711ulaw
Aaron H. DeRooy
Cisco CCNP&CQS-CIPTSS; Infrastructure Specialist
EDS PE/Dedicated Client Engineering - Americas
585.265.8093 (8*225)
585.202.8296 Nextel Cell
Bldg. 200 - 800 Phillips Rd.
MS:0200-08A (Cube W2-15)
Webster, NY 14580
|