Voice over IP Cisco - how to create a software loopback

Author

how to create a software loopback

James Grace

2006-04-27, 6:47 am

I have a remote site that is down. This is a cme. Im able to get into the
gw, and I see that the t1 controller is in a down state. Is the way for me
to determine if the card is bad or good by doing some type of loopback
config on the gw. I am remote to the gw. I think it's a cable issue, but
want to be sure it not a dead t1 controller card

James D. Grace

CCNP CCNA MCSE MCDBA

Sr. System Engineer / Professional Svc.

Digitel Corporation