| Kevin Thorngren 2006-07-26, 1:12 pm |
| Haven't read through all the below so this may have been suggested :-) =
Have you tried placing the GK Trunk in a Region that is G.729 within =
the Region and G.729 to other Regions?
Kevin
On Jul 26, 2006, at 12:58 PM, Ted Nugent wrote:
> Sorry to have posted and dashed but I've been unable
> to work in the lab for the last week but from the
> responses I received it would appear I=92m not
> the only one that=92s having this issue. If you have
> this working can you please reply with your config or
> ideas?
>
> I did some additional testing which proved puzzling.
>
> I created another site with CME and h323 g729 calls
> from that site hit the transcoder and can call
> directly to the CUE Pilot and receives a greeting (sho
> sdspfarm sessions shows active sessions).I debug my
> dial-peers and I can see them match 1000
> (inbound WAN) and 2600 (CUE)
>
> When I setup an h323 gateway on CM and assign a Device
> pool without any CM based transcoder, since it was
> using the CM transcoder previously. I place a call to
> a CME phone and the call is answered as G729. I place
> a call to CUE pilot and get reorder tone (sho sdspfarm
> sessions shows no sessions active). Debug voip
> dialpeer all shows the same dialpeers matched as the
> CME-CME call=85 So it would appear that calls from CME
> to CME are being transcoded fine but from CM to CME
> are not (GK controlled or otherwise). Any ideas here?
> I can attach my configs but they're rather long.
> Thanks
> Ted
>
>
> --- Ted Nugent <tednugent69@yahoo.com> wrote:
>
>
>
> ________________________________________
__________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
> ________________________________________
_______
> cisco-voip mailing list
> cisco-voip@puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
|