|
Home > Archive > Voice over IP Cisco > September 2006 > Cisco 2800/3800 Wic cards
You are viewing an archived Text-only version of the thread.
To view this thread in it's original format and/or if you want to reply to
this thread please [click here]
| Author |
Cisco 2800/3800 Wic cards
|
|
|
| Can someone help me out, can I put a VWIC-2MFT1 in the HWIC slot of the 28/3800 series routers? Or do I need to add onboard DSP modules to support them.
Is there a good link to describe this?
I need a 2800 with on T1 interface to a PBX. What is the best config,
router-vwic+dsp's or
router-nm-hd-ve-vwic (dsp onboard nm card)
Thanks for your help
| |
| Ed Leatherman 2006-09-21, 7:11 pm |
| I just set up a 2811 with a VWIC-2MFT-T1, you will need some onboard DSPs if
you want to use the HWIC slots.
If you go to CCO and search for the DSP Calculator it will tell you what
dsps you will need for your application.
On 9/20/06, bababooey@cox.net <bababooey@cox.net> wrote:
>
> Can someone help me out, can I put a VWIC-2MFT1 in the HWIC slot of the
> 28/3800 series routers? Or do I need to add onboard DSP modules to support
> them.
> Is there a good link to describe this?
>
> I need a 2800 with on T1 interface to a PBX. What is the best config,
> router-vwic+dsp's or
> router-nm-hd-ve-vwic (dsp onboard nm card)
>
>
> Thanks for your help
>
> ________________________________________
_______
> cisco-voip mailing list
> cisco-voip@puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
--
Ed Leatherman
Senior Voice Engineer
West Virginia University
Telecommunications and Network Operations
|
|
|
|
|