| Jonathan Charles 2007-11-24, 1:11 pm |
| With this many errors on the T1 Carrier, the first step is a telco
ticket... get them to run patterns from the DAX to the CSU.
If they run clean to your SmartJack and fail to the CSU, then your
problem is inside wiring.
In all likelihood you have a bad repeater in the field.
Jonathan
On Nov 21, 2007 1:04 PM, zohaib shabir <zohaibshabir@gmail.com> wrote:
> i had the similar issue somewhat closer to what you are saying. Initially
> PBX integration is tested with 3845 router, but when tested with 2811 rou=
ter
> the problem of LCV and PCV came up, resulting in E1 link up and down. then
> what i did was to put the E1 controller in NM-hd2ve module rather than
> directly in HWIC solved the problem for me. however it sounds quite amazi=
ng
> but it happenend andd with same IOS version you are having.
>
>
>
> On 11/21/07, Ryan Ratliff <rratliff@cisco.com> wrote:
>
>
>
> --
> Regards,
> Zohaib Shabir
> Network Engineer(Voice)
> DWP Group, TECH Division Karachi
> Ph:+92-302-8232689
> ________________________________________
_______
> cisco-voip mailing list
> cisco-voip@puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
|