| Patrick Diener 2007-05-29, 7:11 am |
| to debug the e&m signaling:
debug vpm signal
to debug the call routing:
debug voice dialpeer
Regards Patrick
On 5/25/07, James Grace <jgrace@adcapnet.com> wrote:
> ?
>
>
> how to test a t1 cas what are the cmds
> Im trying to test some calls going over the t1 cas wink/start connection. i
> not sure what cmds i can use
>
>
>
> James Grace
>
> Systems Engineer
> Adcap Network Systems, Inc.
> 6865 Shiloh Road East, Suite 250
> Alpharetta, GA 30005
>
> office: 678-456-6986
> direct: 678-456-6761
> jgrace@adcapnet.com
> www.adcapnet.comDisclaimer For ADCAP Network Systems
>
> "The information transmitted is intended only for the person or entity to
> which it is addressed and may
> contain confidential and/or privileged material. Any review, retransmission,
> dissemination or other use of,
> or taking of any action in reliance upon this information by persons or
> entities other than the intended
> recipient is prohibited. If you received this message in error, please
> contact the sender and delete the
> material from all computers."
>
> This original email was sent to the internet for delivery at 25 May 2007
> 09:44:18 -0400
>
>
> ________________________________________
_______
> cisco-voip mailing list
> cisco-voip@puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
|