| Author |
HATS Subfile with single record
|
|
| suitag@my.ibm.com 2005-10-31, 7:51 am |
| Hi. I am rendering my subfile using Selection list. When there is only one
record in my subfile, I dont get to see the data and the link. When I add
a dummy record then I can get to see both the records displayed. Any
input/suggestions would be appreciated ! Thanks.
| |
| Juanma Martinez 2005-10-31, 5:46 pm |
| In article <dk4u6s$a91q$1@news.boulder.ibm.com>, suitag@my.ibm.com says...
>
> Hi. I am rendering my subfile using Selection list. When there is only one
> record in my subfile, I dont get to see the data and the link. When I add
> a dummy record then I can get to see both the records displayed.
>
Which version of HATS are you using?
--
Juanma Martínez
| |
| suitag@my.ibm.com 2005-11-01, 2:45 am |
| HATS 6.0.2. Have you come across this as well? Thanks.
| |
| Juanma Martinez 2005-11-01, 7:45 am |
| In article <dk708d$6lpo$1@news.boulder.ibm.com>, suitag@my.ibm.com says...
> HATS 6.0.2. Have you come across this as well? Thanks.
>
Yes.
Edit the subfiles rule for your project (or the one you've applied to that
screen) and in the Data tab, check the entry "Data not required"
--
Juanma Martínez
| |
| suitag@my.ibm.com 2005-11-01, 8:45 pm |
| Hi. Thanks for the suggestion but am still facing the same problem. Also
not sure if I mentioned that I am rendering this "one-record subfile"
using selection list component.Any other suggestion I can try? Thanks a
lot.
| |
|
| Hello,
Did you try setting the minimum require options in the selection list component to one?
Thanks,
Alisa
<suitag@my.ibm.com> wrote in message news:dk97ts$839m$1@news.boulder.ibm.com...
Hi. Thanks for the suggestion but am still facing the same problem. Also not sure if I mentioned that I am rendering this "one-record subfile" using selection list component.Any other suggestion I can try? Thanks a lot.
|
|
|
|