05-21-05 10:46 PM
On 21 May 2005, internet@spamhole.com wrote:
>I am looking for recommendations on how to send an untraceable
>back-to-me email. The purposes of this is to report severe OSHA
>violations at my employer.
>
>Message untraceablity is desired, NOT message encryption. I could care
>less about encryption. UNTRACEABILITY is required.
>
>Based on my own research, I am planning to do the following
>
>1) Direct my browser to connect to internet
Busted. You can not trust your browser. It sends all kinds of info on you,
and can be a launch pad for almost any program.
> via proxy server, located
>overseas. A list of which are found at
>http://www.proxy4free.com/page1.html
>
>2) Upon doing that, I will go to internet site
>
>https://mixmaster.autistici.org/cgi...xemail-user.cgi OR
>
>https://riot.eu.org/anon/remailer.html.en
>
>3) Once I do that, I will compose and send the message using the
>maximum number of remailers offered (4 to 6).
>
>
>an additional note on #1 above is I may go to public library computer,
>configure browser, and then do steps 2 thru 3. Necessary?
>
>comments, thoughts?
>
>again, encryption is not important. However I need UNTRACEABILITY
Well, in order to achieve UNTRACEABILITY, ENCRYPTION will be required. You
should also spend a little time learning how to use Jack B Nymble 2.1.4 or
Quicksilver.
One or the other will be REQUIRED for UNTRACEABILITY, with the ability to
REPLY to you.
You'll need JBN or QS, PGP, and possibly mixmaster.
It can be done, but you need to put in some time.
>
>thanks
[ Post a follow-up to this message ]
|