I've just got my Sipura SPA3000 so getting to grips with as as fast as
I can. I've got Sipgate setup on line 1 which seems to be working fine
for calls in and out. I'm not trying to configure Voipbuster as
gateway 1. My current settings are :

Line 1 tab settings
Gateway 1 : <username>@sip.voipbuster.com
GW1 NAT Mapping Enable: Yes
GW1 Auth ID: <username>
GW1 Password: <password>

Settings seem ok as work on PAP2, switched back to PAP2 and Voipbuster
is working today :-)

The dial plan is set to :

(xx.|*xx.|<#1,:>xx.<:gw1> )

I pick up handset, press #1 and get a constant tone (like
unavailable). Dial a number and dials then beeping. So I've not got
something right yet. Still trying a few settings and googling but any
help would be much appriciated. tia

oh all ports are open as SPA3000 in DMZ.

[ Post a follow-up to this message ]

Bleh wrote:

> The dial plan is set to :
>
> (xx.|*xx.|<#1,:>xx.<:gw1> )
>

should be <:@gw1> ?

Phil

[ Post a follow-up to this message ]

On 20 Jun 2006 01:32:32 -0700, "PhilT" <newsnet@gmail.com> wrote:

>
>Bleh wrote:
> 
>
>should be <:@gw1> ?
>
>Phil


I can't believe I missed that...yes it not works. Thanks

[ Post a follow-up to this message ]