> Hi all,
> Here its my scenario:
> 
> I receive a call via E1 in a 3640 router with an E1 card,  then via dial-p
eer voice XXX voip it goes to another cisco router (2801) who runs a Vxml ap
plication, but the call ends ans nothing happens. Via debug, I saw that the 
application starts but > ...> ..
> 
> I try the same vxml in another router directly via a dial-peer voice XXX P
OTS and run perfectly.
> 
> Any ideas¿?
> 
> There are the configuration in the routers
> 
> cisco 3640:
> 
> Dial-peer voice 123 voip
> Destination-pattern 123
> Session target ipv4:10.10.10.1
>  dtmf-relay h245-alphanumeric
>  codec g711ulaw
>  no vad
> 
> 
> cisco 2801
> 
> interface Loopback0
>  ip address 10.10.11.1 255.255.255.0
> !
> dial-peer voice 123 voip
>  service acme
>  destination-pattern 123
>  session target ipv4:10.10.11.1
>  incoming called-number 123
>  dtmf-relay h245-alphanumeric
>  codec g711ulaw
>  no vad
> 
> 
> 
> Thanks in advance

Attachment:
This has been downloaded 0 time(s).

[ Post a follow-up to this message ]