I'm going to retract my earlier statements.

After shutting down the CallManagers completely, the 7960 (FW 7.22)
phone does not register back to SRST router after power cycling the
phone.

Perhaps the phone needs to TFTP from the CCM before it can register to
the SRST router.

This seems like a limitation of SRST.  I can see a bad storm knocking
out a T1 line and commercial power.

Is there something I'm missing or is the answer to have a PoE switch
and a SRST router on a UPS?

Justin




On 6/28/06, Lelio Fulgenzi <lelio@uoguelph.ca> wrote:
>
> I'm wondering if stopping the CCM service is enough of a test. Could there
> perhaps be another service that the SRST router is connecting to?
>
> I don't see how the SRST router and phones can continue to operate after a
> reboot if connectivity to the cluster is lost.
>
> --------------------------------------------------------------------------
------
>
> Lelio Fulgenzi, B.A.
> Senior Analyst (CCS) * university of Guelph * Guelph, Ontario N1G 2W1
> (519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
>  ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> "I can eat fifty eggs." "Nobody can eat fifty eggs."
>
> ----- Original Message -----
> From: Justin Steinberg
> To: Ryan Ratliff
> Cc: Lelio Fulgenzi ; Ted Nugent ; cisco-voip@puck-nether.net
> Sent: Wednesday, June 28, 2006 4:13 PM
> Subject: Re: [cisco-voip] Link to primary CCM fails while logged in
> withExtension Mobility
>
> I did a little afternoon testing on this power cycle question I had.
>
> I registered a 7960 running FW 7.2(2) to CCM in my lab and then
> stopped the CCM service.  The phone successfully failed over to my
> SRST 3.3 router.
>
> Then I power cycled the SRST router and when the router came back
> online the phone registered back to SRST with the correct DN.
> Rebooted the phone and it still reregistered with the correct DN.
>
> It even registered back to SRST with the correct DN after power
> cycling the phone and SRST router at the same time.
>
> I then power cycled the router and did a factory reset procedure on
> the 7960, choosing to save the network config during the process.
> After the phone reset it registered back to the SRST router but
> without any DN.
>
> So the phone must save the most recent DN somewhere in flash and
> retains this even through power failure.
>
> I did not test this with EM.
>
> Justin
>
>
>
>
> On 6/28/06, Ryan Ratliff <rratliff@cisco.com> wrote: 
> ---------------------------------------------------------------------- 
>  ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
>

[ Post a follow-up to this message ]