Hi
i need your help about 2 problems below

1.   I got CCM 4.1.3 and 2851 gateway,
there is one VIC2-4FXO  card and  FCT devices  which are connected to these 
FXO ports for GSM calls

the problem is that sometimesFCT s are locked. And the customer wanna see wh
ich one is locked
Is it possible to see fxo port status from callmanager . I can check it from
 gateway by  executing  ' show voice port summary'   but I dont know how to 
see from CCM webpage,i wanna see if the port is really used at that moment. 



2.Also another thing ;  when i call GSM  from fct devices , sometimes ip pho
ne displays that it is connected and the connected time is increasing but ac
tually the call is not set up. I wait 50-55 seconds but there isno even ring
 tone. 
And then i  close the phone adn call again.


thanks  a lot


       
 ________________________________________
____________________________________
________
Boardwalk for $500? In 2007? Ha! Play Monopoly Here and Now (it's updated fo
r today's economy) at Yahoo! Games.
http://get.games.yahoo.com/proddesc...monopolyherenow

[ Post a follow-up to this message ]

You need to launch the RTMT,  It will display the status of the port in
real time. 

http://www.cisco.com/en/US/products...ucts_administra
tion_guide_chapter09186a008062a98c.html#wp28847

 

Regards,

 

Walter Ocampo

System Network Analyst

Office of Information Technology

540 S.E 3rd. Ave, Suite 300

Fort Lauderdale, FL 33301

(954) 357 8041 Cell (954) 632 8228

wocampo@broward.org

 

From: cisco-voip-bounces@puck.nether.net
[mailto:cisco-voip-bounces@puck.nether.net] On Behalf Of gokhan senol
Sent: Thursday, August 09, 2007 10:43 AM
To: cisco-voip@puck.nether.net
Subject: [cisco-voip] fxo ports and fct CCM 4.1.3

 

Hi

i need your help about 2 problems below

 

1.   I got CCM 4.1.3 and 2851 gateway,

there is one VIC2-4FXO  card and  FCT devices  which are connected to
these FXO ports for GSM calls

 

the problem is that sometimes FCT s are locked. And the customer wanna
see which one is locked

Is it possible to see fxo port status from callmanager . I can check it
from gateway by  executing  ' show voice port summary'   but I dont know
how to see from CCM webpage,i wanna see if the port is really used at
that moment. 

 

 

 

2.Also another thing ;  when i call GSM  from fct devices , sometimes ip
phone displays that it is connected and the connected time is increasing
but actually the call is not set up. I wait 50-55 seconds but there is
no even ring tone. 

And then i  close the phone adn call again.

 

 

thanks  a lot

 

________________________________

Take the Internet to Go: Yahoo!Go puts the Internet in your pocket:
<http://us.rd.yahoo.com/evt=48253/*h.../go?refer=1GNXI
C>  mail, news, photos & more. 

[ Post a follow-up to this message ]