Hi all,

I have a C2A application that works perfectly however, I dont appear to be
able to create a wire within the development environment (hold CTRL).  I am
also unable to install the C2A wiring portlet.  Any ideas or is this just
the way it is?

Kind Regards,

Tony Gallardo

[ Post a follow-up to this message ]

Portlet supports C2A does not necessarily mean you can wire that portlet.
Portal InfoCenter
http://publib.boulder.ibm.com/pvc/w.../portal/toolkit is updated
recently and answer to Q22 says you cannot install portlets to
Test Environment.

url

[ Post a follow-up to this message ]

Thanks for the response...

The portlet does register an output property.  When I export the application
from WSAD and install into my WPS environment I am able to create a wire
using the wiring portlet so I know that wiring between the portlets works
fine.

I guess if I am unable to install the wiring portlet into the test
environment then so be it but should I be able to use the CRTL key to create
a wire in WSAD?

Kind Regards,

Tony
"url" <kessler297-NOSPAM@hotmail.com> wrote in message
news:c6r42i$7fn6$1@news.boulder.ibm.com...
> Portlet supports C2A does not necessarily mean you can wire that portlet.
> Portal InfoCenter
>
http://publib.boulder.ibm.com/pvc/w.../wpsc2acnc.html
> indicates, to support wiring, the source portlet must register output
> property, which is not necessary for C2A to work without wiring.
> Probably your portlet does not register output property.
>
> And, if you are trying to install C2A wiring portlet to test
> environment,  you just cannot.
> The FAQ on http://www.ibm.com/websphere/portal/toolkit is updated
> recently and answer to Q22 says you cannot install portlets to
> Test Environment.
>
> url
>

[ Post a follow-up to this message ]