09-26-07 12:11 AM
for general setup of CUCME refer to the System Administrator Guide
http://www.cisco.com/en/US/products...s_configuratio=
n_guide_book09186a00807c5776.html
if you just are not sure how to use the load command for the 7906,
check this out:
http://www.cisco.com/en/US/products...stallation_gui=
de09186a00807aae21.html
<snipe>
When configuring the load command for IP phones such as the Cisco
Unified IP Phone 7906G, 7911G, 7941G, 7941GE, 7961G, 7961GE, 7970G,
and 7971G, configure only the filenames that are marked with an
asterisk (*) in the table below.
</snipe>
Regards
Patrick
On 9/20/07, Ren=E9 Rojas <rrojas@infodesa.es> wrote:
>
>
>
>
> Please i need your help, I have a router 2811, but don=B4t load the tele=
phone 7906
>
> routerVoIP(config)#telephony-service
> routerVoIP(config-telephony)#load ?
> The flash:
> 12 662 Sep 10 2007 12:02:12 +00:00 term06.default.loads
> 17 2382199 Sep 11 2007 07:38:08 +00:00 cvm11sccp.8-3-1-22.sbn
> 18 521707 Sep 11 2007 07:53:32 +00:00 cnu11.8-3-1-22.sbn
> 19 2489775 Sep 11 2007 07:54:26 +00:00 apps11.8-3-1-22.sbn
> 20 307034 Sep 11 2007 07:55:44 +00:00 jar11sccp.8-3-1-22.sbn
> 21 326254 Sep 11 2007 07:57:44 +00:00 dsp11.8-3-1-22.sbn
> 22 662 Sep 11 2007 07:58:56 +00:00 term11.default.loads
>
> My router cisco 2811 version 12.4(12a)
>
> What do i need load?
>
>
> Best regards
>
>
>
>
> ________________________________________
_______
> cisco-voip mailing list
> cisco-voip@puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
[ Post a follow-up to this message ]
| 
