Hi Cucumber,

did you try to adjust the the hook-flash timer under the voice-port?
This timer has to equal on the voice-port and the connected telephone.

/Robert
 
September 2007 um 17:53 in Nachricht  3ab0adee131ef58c7afb0ea50017a410:[vbcol=
seagreen]
> Analog phones can send and receive calls from IP phones, but
>   when pressing the hookflash key at the analog phone, the analog phone do
es
> not get a dial tone in order to transfer the call 
>
>   Phones are hooked into FXS ports on a 2811 and will use G729 codec.
>
>   I have already checked the "Media Termination Point required" check box 
in
> the gateway configuration at call manager (using unified call manager 4.2(
3)
> ). I thought that would do the trick, but it didnt, any ideas?
>
>   This is the gateway config (IOS version 12.4(3g) spservicesK9)
>
>   !
> version 12.4
> service timestamps debug datetime msec
> service timestamps log datetime msec
> service password-encryption
> !
> ip subnet-zero
> !
>  !
> ip cef
> !
> !
> no ip domain lookup
> !
> voice-card 0
>  no dspfarm
> !
> !
> !
> !
> interface Loopback0
>  ip address X.X.X.X 255.255.255.255
>  h323-gateway voip bind srcaddr X.X.X.X
> !
> !
> ip classless
> ip route 0.0.0.0 0.0.0.0 X.X.X.X 254
> !
> !
> control-plane
> !
> !
> !
> voice-port 0/1/0
>  signal loopStart
> !
> voice-port 0/1/1
>  signal loopStart
> !
> dial-peer voice 10 pots
>  destination-pattern 50001
>  port 0/1/0
> !
> dial-peer voice 20 pots
>  destination-pattern 50002
>  port 0/1/1
> !
> dial-peer voice 1 voip
>  preference 1
>  destination-pattern 1...
>   session target ipv4:X.X.X.X
>  dtmf-relay h245-alphanumeric
>  codec g729r8 bytes 40
>  ip qos dscp cs3 media
>  ip qos dscp cs3 signaling
> !
> dial-peer voice 4 voip
>  preference 2
>  destination-pattern 1...
>  session target ipv4:X.X.X.X
>  dtmf-relay h245-alphanumeric
>  codec g729r8 bytes 40
>  ip qos dscp cs3 media
>  ip qos dscp cs3 signaling
>  !
>
>
>
> ---------------------------------
> Be a better Globetrotter. Get better travel answers from someone who knows
.
> Yahoo! Answers - Check it out.

[ Post a follow-up to this message ]

Hello!

Yeah I have tried this without luck, I guess it only works if the H323 gatew
ay has a FXO
connection to a PBX

Robert Schuknecht <rschuknecht@gmx.de> wrote:
Hi Cucumber,

did you try to adjust the the hook-flash timer under the voice-port?
This timer has to equal on the voice-port and the connected telephone.

/Robert
 
September 2007 um 17:53 in Nachricht  3ab0adee131ef58c7afb0ea50017a410:[vbcol=
seagreen]
> Analog phones can send and receive calls from IP phones, but
> when pressing the hookflash key at the analog phone, the analog phone does
> not get a dial tone in order to transfer the call 
>
> Phones are hooked into FXS ports on a 2811 and will use G729 codec.
>
> I have already checked the "Media Termination Point required" check box in
> the gateway configuration at call manager (using unified call manager 4.2(
3)
> ). I thought that would do the trick, but it didnt, any ideas?
>
> This is the gateway config (IOS version 12.4(3g) spservicesK9)
>
> !
> version 12.4
> service timestamps debug datetime msec
> service timestamps log datetime msec
> service password-encryption
> !
> ip subnet-zero
> !
> !
> ip cef
> !
> !
> no ip domain lookup
> !
> voice-card 0
> no dspfarm
> !
> !
> !
> !
> interface Loopback0
> ip address X.X.X.X 255.255.255.255
> h323-gateway voip bind srcaddr X.X.X.X
> !
> !
> ip classless
> ip route 0.0.0.0 0.0.0.0 X.X.X.X 254
> !
> !
> control-plane
> !
> !
> !
> voice-port 0/1/0
> signal loopStart
> !
> voice-port 0/1/1
> signal loopStart
> !
> dial-peer voice 10 pots
> destination-pattern 50001
> port 0/1/0
> !
> dial-peer voice 20 pots
> destination-pattern 50002
> port 0/1/1
> !
> dial-peer voice 1 voip
> preference 1
> destination-pattern 1...
> session target ipv4:X.X.X.X
> dtmf-relay h245-alphanumeric
> codec g729r8 bytes 40
> ip qos dscp cs3 media
> ip qos dscp cs3 signaling
> !
> dial-peer voice 4 voip
> preference 2
> destination-pattern 1...
> session target ipv4:X.X.X.X
> dtmf-relay h245-alphanumeric
> codec g729r8 bytes 40
> ip qos dscp cs3 media
> ip qos dscp cs3 signaling
> !
>
>
>
> ---------------------------------
> Be a better Globetrotter. Get better travel answers from someone who knows
.
> Yahoo! Answers - Check it out.



---------------------------------
Don't let your dream ride pass you by.    Make it a reality with Yahoo! Auto
s.

[ Post a follow-up to this message ]

________________________________________
_______
cisco-voip mailing list
cisco-voip@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

[ Post a follow-up to this message ]

If you need features with fxs you might want to look into SCCP for FXS
controller as you would with a VG224 and h323 for and PSTN/PRI access etc.
(see the link you need CM4.2+ and a certain rev of IOS depending on your
hardware).

http://www.cisco.com/en/US/partner/....html#wp1304455

<http://www.cisco.com/en/US/products....html#wp1049404>





On 9/20/07, Cucumber Green <greencucumber2007@yahoo.com> wrote:
>
> Hello!
>
> Yeah I have tried this without luck, I guess it only works if the H323
> gateway has a FXO
> connection to a PBX
>
> *Robert Schuknecht <rschuknecht@gmx.de>* wrote:
>
> Hi Cucumber,
>
> did you try to adjust the the hook-flash timer under the voice-port?
> This timer has to equal on the voice-port and the connected telephone.
>
> /Robert
> 
> September 2007 um 17:53 in Nachricht 3ab0adee131ef58c7afb0ea50017a410: 
> does 
> in 
> 4.2(3) 
> knows. 
>
>
>  ------------------------------
> Don't let your dream ride pass you by. Make it a reality<http://us.rd.yahoo.com/
evt=...YW1j
YXI->with Yahoo! Autos.
>
>
>  ________________________________________
_______
> cisco-voip mailing list
> cisco-voip@puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>

[ Post a follow-up to this message ]