Customer has a Trunk port set for paging on a Nortel connected to a
no-name paging unit.

 

Is a "Nortel Paging Port" justa FXO?

 

I've connected up my VWIC-2FXO for Loop Start, I go offhook but never
get connected to paging unit.



Debug vpm signal

*Aug 17 05:02:16.115: htsp_timer_stop

*Aug 17 05:02:16.115: htsp_timer_stop2

*Aug 17 05:02:16.115: [2/1] set signal state = 0x4 timestamp = 0

*Aug 17 05:02:16.127: htsp_process_event: [2/1, FXOLS_ONHOOK,
E_HTSP_RELEASE_REQ]fxols_onhook_release

*Aug 17 05:02:16.219: htsp_process_event: [2/1, FXOLS_ONHOOK,
E_DSP_SIG_0100]

*Aug 17 05:02:17.139: htsp_timer_stop3 htsp_setup_req

*Aug 17 05:02:17.151: htsp_process_event: [2/1, FXOLS_ONHOOK,
E_HTSP_SETUP_REQ]fxols_onhook_setup

*Aug 17 05:02:17.151: [2/1] set signal state = 0xC timestamp = 0

*Aug 17 05:02:17.151: htsp_timer - 1300 msec

*Aug 17 05:02:17.303: htsp_process_event: [2/1, FXOLS_WAIT_DIAL_TONE,
E_DSP_SIG_1100]fxols_power_denial_proc

*Aug 17 05:02:17.307: htsp_timer2 - 1000 msec

*Aug 17 05:02:17.307: htsp_timer_stop

*Aug 17 05:02:18.307: htsp_process_event: [2/1, FXOLS_WAIT_DIAL_TONE,
E_HTSP_EVENT_TIMER2]fxols_timer2_proc

*Aug 17 05:02:18.307: htsp_timer_stop

*Aug 17 05:02:18.307: htsp_timer_stop2

*Aug 17 05:02:18.307: [2/1] set signal state = 0x4 timestamp = 0

*Aug 17 05:02:18.319: htsp_process_event: [2/1, FXOLS_ONHOOK,
E_HTSP_RELEASE_REQ]fxols_onhook_release

*Aug 17 05:02:18.411: htsp_process_event: [2/1, FXOLS_ONHOOK,
E_DSP_SIG_0100]




-----------------------------------------
Disclaimer:

This e-mail communication and any attachments may contain
confidential and privileged information andis for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  Ifyou have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.

[ Post a follow-up to this message ]