Hello,
I created this AIC using vb 6.0 and registered it as a COM+ application in
my test machine.  Everything works fine.  and then i deployed it to my QA
machine(just a dll file), register it as COM+ application and configure it i
n
my messaging port. First time around i send data to it, it delivered my
message from point A to point B.  I went back to my test machine and made
some changes to my AIC and then compiled it and also copied the latest dll t
o
QA.   Problem is when i send data to this AIC it doesn't load my latest dll.
Data will get to point A to point B but my changes are not going in effect.
Please advise if you have any insight.

TIA

[ Post a follow-up to this message ]

You will need to stop the COM+ application this AIC is running under.
Unregister your old AIC. Replace it with your new AIC and register it. Then
restart the COM+ application.

--
Jeff Lynch
"A BizTalk Enthusiast"
http://dotnetjunkies.com/WebLog/jlynch/


"BizTalkUser" <BizTalkUser@discussions.microsoft.com> wrote in message
news:27C1CE89-F44C-4DA3-A8F4-7945F39257A5@microsoft.com...
> Hello,
>  I created this AIC using vb 6.0 and registered it as a COM+ application
> in
> my test machine.  Everything works fine.  and then i deployed it to my QA
> machine(just a dll file), register it as COM+ application and configure it
> in
> my messaging port. First time around i send data to it, it delivered my
> message from point A to point B.  I went back to my test machine and made
> some changes to my AIC and then compiled it and also copied the latest dll
> to
> QA.   Problem is when i send data to this AIC it doesn't load my latest
> dll.
> Data will get to point A to point B but my changes are not going in
> effect.
> Please advise if you have any insight.
>
> TIA

[ Post a follow-up to this message ]